Description
1,5 W IP65 Solar LED Wall Light with Motion Sensor
The 1,5 W IP65 Solar LED Wall Light with Motion Sensor is an outdoor wall fixture powered by a solar panel located on top of the housing. The light can be used by an entrance, on a garage wall or along a pathway where access to conventional electrical wiring is limited.
Two finishes are available: black and white. Both feature the same housing and lighting specifications. Two lighting directions, front and rear, combine practical pathway illumination with subtle lighting that highlights the wall surface.
The light has a built-in dusk and motion sensor. When motion is detected at night, it increases its brightness, then switches to dimmer lighting after a set period of inactivity. This solution suits spaces used at different times, without the need to switch the light on manually every day.

Solar Wall Light with Two Operating Modes and Motion Sensor
The 0,7 Wp polycrystalline panel converts solar energy to power the built-in lighting. There is no need to run a power cable from the building. To ensure the light can charge properly, choose a location where the panel has access to daylight.
Mode A provides automatic lighting after dark and increases brightness when motion is detected. Once motion stops, the light dims after approximately 20 seconds. If the battery has less than 30% charge remaining, the energy-saving mode may switch off the front light and leave the dimmer rear lighting on.
In mode B, the wall light operates at 50% brightness after dusk. After five hours, or when the battery charge drops below 30%, it switches to energy-saving operation. Motion detected at this stage activates the lighting according to this mode, and the light dims again after approximately 20 seconds without motion.
The motion sensor covers a 120° angle and operates within a range of less than 6 m. A button allows you to switch between modes A and B and turn the light off. This is a useful feature when choosing between more frequent illumination and more economical operation.










Product Specifications
- Type: outdoor solar wall light
- LED power: 1,5 W
- Luminous flux: 220 lm
- Light colour: neutral white 4000 K
- Solar panel: polycrystalline 0,7 Wp
- Dusk and motion sensor: yes
- Motion sensor angle: 120°
- Sensor range: less than 6 m
- Modes: A and B
- Protection rating: IP65
- Built-in LED light source: yes
- Colour: black or white
Product Dimensions
- Width: 9,5 cm
- Height: 14 cm
- Depth: 7,5 cm
- Gross weight: 0,3 kg









Why Choose a Solar LED Wall Light?
- No power cable required – powered by energy collected through the panel on the housing.
- Two lighting directions – light from the front and rear of the wall fixture.
- Automatic response to motion – brighter lighting when someone walks past.
- Modes A and B – operation adapted to the location and usage requirements.
- IP65 protection – a design suitable for outdoor conditions.
- Two housing colours – black or white.
- Neutral white 4000 K – lighting with a luminous flux of 220 lm.
Who Is This Product Suitable For?
This wall light can be useful by a house or garage entrance, along a section of a garden pathway or beside a garden gate when lighting is needed without installing cables. The black version creates a stronger contrast against a light-coloured facade, while the white version can produce a subtler effect on a light-coloured wall.
When choosing a location, consider the panel’s exposure to sunlight, the route taken by people walking past and the mounting height in relation to the sensor’s range. The actual lighting duration depends on the amount of energy collected and the operation of the selected mode.
Summary
The 1,5 W Solar LED Wall Light combines solar power, front and rear lighting, and a motion sensor. Two modes allow you to select its operation at night, while the IP65 rating allows outdoor installation. Choose black or white and position the panel in a location with good exposure to daylight.









Reviews
There are no reviews yet.